Next you can unplug the red positive pole cable. We advise against using metal pliers, but if you use them, you must make sure that you do not touch any other parts of the body. If the pole clamp is very tight, you can open it with pliers. First remove the black cable from the negative pole. To clean the battery on your Honda Pilot, you have to remove the pole cables first, which requires no special knowledge, just a little concentration, as the order is very important. If you discover white deposits or silvery-green deposits, but no further cracks or damage, you do not have to replace the battery, just clean it. If you lift the rubber covers over the two battery terminals, you can check the terminals for corrosion. To know if your Pilot’s starting problems are from dirty battery contacts, you need to investigate them. Start the donor vehicle and then your Pilot. Next connect black cable to the negative terminal of donor battery, then to the bare metal in the engine bay of your Pilot. If dead battery is the reason for the breakdown of your Pilot, you can easily jump start it using jumper cables and a healthy battery from another vehicle, or using a battery booster if available.įirst connect red cable to the positive terminal of your Pilot’s dead battery, then to the positive terminal of donor battery. Because the battery may have a defect with these measured values and must be replaced. Values above 14 or below 11.5 volts require an expert assessment of the condition of the car battery. checking the voltage, usually results in values of approx. Successful testing of the car battery, i.e. Before the test, the multimeter is set to the voltage range of the battery and connected to its plus and minus poles. The voltage of the battery on your Honda Pilot can be measured precisely with a multimeter. The 12v battery on Honda Pilot is located under the air duct, first remove the front engine bay cover and then the air duct to gain access to the battery. A new battery only develops its full capacity over time. If a new car battery has been installed, the battery may not have yet reached its full capacity. A test can be done to measure the voltage between the battery poles, check the acid level and assess the condition of the starter battery. Investigating more closely and doing a battery voltage test will clarify whether the starting problem is due to the battery. If your Pilot’s engine won’t crank or cranks very slowly, then the most likely culprit is a weak or dead 12v battery.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |